Attach The Pendant Arm To The Mounting Plate - Bosch VG5 600 Series Installation Manual

AutoDome 600 Series Analog PTZ Camera
2.8.1

Attach the Pendant Arm to the Mounting Plate

The bottom hinge pin of the Pendant Arm is provided with a Hinge Pin Stop to hold the hinge
open while attaching the arm to the Mounting Plate.
1.
Figure 2.12
2.
3.
4.
Bosch Security Systems, Inc.
Compress the bottom hinge pin by pushing the pin lever downward and rotating it
behind the Hinge Pin Stop.
Connect Pendant Arm to Mounting Plate
Open the top hinge by pushing its pin lever up and holding it.
Note: Both Hinge Pins must be fully compressed to open (unlock) the hinges of the
Pendant Arm and before proceeding to the next step.
While continuing to hold the top hinge pin open, align the top and bottom hinges of the
Pendant Arm to their mating points on the Mounting Plate. Refer to Figure 2.12, above,
for an illustration.
Once you have the hinges aligned, release the top hinge pin to engage its mating hinge on
the Mounting Plate. Then release the bottom hinge pin from the Hinge Pin Stop to lock
the Pendant Arm to the Mounting Plate.
Installation Manual
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 29
F.01U.265.793 | 2.0 | 2012.02