Setting The Time Code - Canon EOS-1 D X Mark II Instruction Manual

Setting the Time Code

3
Count Up
Rec run : The time code counts up only while you are shooting a
movie. The time code will continue in the sequence of the
movie files captured.
Free run : The time code counts up whether you are shooting a
movie or not.
Start Time Setting
You can set the time code's start time.
Manual input setting: You can freely set the hour, minute, second,
Reset
Set to camera time : Sets hours, minutes, and seconds to match the
If you shoot a High Frame Rate movie with [Free run] set, the time code
will not be appended.
If [Free run] is set and you change the time, zone, or daylight saving
time (p.55), the time code will be affected.
If you play back an MP4 movie with a device other than the camera, the
time code may not be displayed properly.
326
The time code is a time reference
recorded automatically to synchronize
the movie during movie shooting. It is
recorded at all times in the following
units: hours, minutes, seconds, and
frames. It is mainly used during movie
editing.
Set the time code with [z5: Time
code].
and frames.
: The time set with [Manual input setting] and
[Set to camera time] is reset to "00:00:00." or
"00:00:00:" (p.329).
camera's internal clock. "Frames" will be set to
"00".