Develop D1531iD User Manual page 68

5
<Multiple Bypass Tray>
1
Position the original.
❍ Original Loading (p.4-1)
2
Adjust the Paper Guides and the
Bypass Tray Extender to the size of
the paper. Load a stack of paper so
that the front side of the paper faces
down. At this time, gently insert the
paper stack until it is stopped. Note
that the Bypass Tray location
indicator on the control panel lights.
? Do you want to use a type of
paper other than plain paper?
➜ To use cards, postcards, or OHP transparencies, first change the
type of paper selecting User's Choice. Refer to "Paper Type
(Bypass Tray)" (p.7-9).
➜
When loading cards or postcards, be sure to smooth out any curl
in the paper.
3
Press the [Bypass Tray Size Select]
key until the size of the paper
loaded blinks.
❍ If the paper used is of custom
size, its size must be input.
Refer to the "Custom Size Input
(Bypass Tray)" procedure that
follows. (p.5-9)
? Do you know which FLS size
has been set?
➜ The FLS size has been set to 210 mm × 330 mm (8-1/4 × 13).
Ask your Tech. Rep. if you want to change the FLS size.
4
Press the [Enter] key to light the size of the paper loaded.
5
Make any other necessary settings.
❍ Zoom Ratio (p.5-11)
❍ Image Density (p.5-16)
6
Press the [Start] key.
5-8
Making Copies
D1531iD/D1831iD