Install The Electric Motor - GREAT PLANES ZERO Instruction Manual

8. Use medium-grit sandpaper to roughen the fl ange on
the belly pan and remove any minute inconsistencies so glue
will adhere. Test-fi t the belly pan to the bottom of the wing
and make any adjustments necessary for a good fi t.
9. With the belly pan in position, tape one side down to
the wing. Use thin CA dispensed through a fi ne tip to glue the
other side of the belly pan to the wing—little CA is required and
use care not to apply too much CA at the front and back of
the belly pan so excess will not glue the wing to the fuselage.
10. Remove the tape and glue the other side of the belly
pan to the wing. After the CA has hardened, a paper towel
square dampened with CA debonder may be used to wipe
off any excess CA or CA fog.
11. Carefully trim the corners of the belly pan that protrude
beyond the fuselage and the wing.
If installing a glow engine skip to Mount the Glow Engine
on page 12.

Install the Electric Motor

1. Glue together both pieces of the front plate and the
back plate for the EP motor mount box alternating the wood
grain direction of each set. NOTE: These parts may already
be glued together by the factory.
9