Table of Contents
Advertisement
2. Press 4-40 blind nuts into the front plate and glue them
in with CA.
3. With the blind nuts on the inside of the assembly, glue
all the motor mount box parts together—it's quick and easy
just to hold the assembly together while gluing it with thin CA.
4. Glue the triangle stock reinforcements around the front
and back plates—it's easy to position them with a hobby
blade and glue them down with medium CA.
5. Drill 1/16" [1.6mm] pilot holes through the "O" marks
in the fi rewall, then enlarge the holes with a 5/32" [4mm] drill.
Insert 6-32 blind nuts into the back of the holes.
6. Cut the rest of the way through the partially cut air inlet
in the fi rewall and remove the piece.
7. Mount the motor mount box to the fi rewall with four 6-32
x 3/4" Phillips screws and #6 lock washers and fl at washers
and threadlocker.
10
Advertisement
Table of Contents
