Assemble The Wing - GREAT PLANES ZERO Instruction Manual

ASSEMBLE THE WING

Refer to this image while mounting the aileron servos
and hooking up the ailerons.
Do the left wing fi rst...
Cut out
2. If necessary, enlarge the servo cutout to fi t your servo.
3. Use the string to pull the aileron servo wire through
the wing (or just guide the servo wires down through the
holes without using the string) and fi t the servo into the
servo openings.
1. Attach a 6"
[150mm]
extension to each
aileron servo and
secure with the
included 3" [75mm]
shrink tubing cut
into two 1-1/2"
[40mm] pieces.
Enlarge the aileron
servo mount as necessary
to fit your servos.
4. Drill 1/16" [1.6mm] holes for the servo mounting screws
in the wing and for the control horn screws on the aileron
(use care not to drill through the top of the aileron). Mount the
servo and horn, make the pushrod and hook up the aileron
servo
using the hardware shown.
5. After mounting the aileron horns, remove the screws,
harden the holes with a few drops of thin CA, allow to harden,
and then reinstall the screws.
6. Hook up the aileron servo in the right wing the same way.
1/8" [ 3 mm ]
7. Use a fl at landing gear strap as a guide to drill 3/32"
[2.4 mm] holes into the landing gear block in the left wing–
angle the straps so the holes will be 1/8" [3 mm] from the
edge of the groove.
8. Mount the main landing gear to the rails with two straps
and four M3 x 10 screws.
5