Optional Elbow Flue Adapter Installation; Securing Stove Pipe/Liner To Flue Collar; Leveling Legs - Quadra-Fire GRAND-MBK-AU Owner's Manual

B. Optional Elbow Flue Adapter Installation
Optional use of a Simpson Duravent 15° Universal Elbow
Part Number 4615 may be purchased directly through your
local Simpson Durvent Pipe Distributor or from your local
Quadra-Fire dealer, Part Number DV-4615.
Figure 20.1 shows a vertical installation and also how to
create an optional 30° elbow installation.
The 15° elbow may be secured directly to the fl ue collar.
Follow the pipe manufacturer's instructions for using
screws or rivets for attachment. Most pipe manufacturer's
152 mm diameter fl ue liners may be attached directly to the
top of the 15° elbow.
A
30 degree
Figure 20.1
Flue A
Adapter
Vertical 344 mm
30 Degree 371 mm
October 12, 2015
o
30
B
A
Vertical
B
532 mm
525 mm
C. Securing Stove Pipe/Liner to Flue Collar
1. There are 4 pre-drilled holes in the fl ue collar 90° apart.
Attach the fl ue collar to the stove pipe/liner. If the seal is
questionable use stove mastic Figure 20.2
2. Attach gasket to bottom side of fl ue collar with a thin coat
of silicone.
Flue Collar
Figure 20.2
D. Leveling Legs
1. Remove the 2 screws already installed on each leg.
2. Move legs to the desired height.
B
3. Re-install the screws to secure in place.
Remove 2 screws from both sides.
Adjust the legs up or down to level
appliance.
Figure 20.3
7075-205B
Voyageur Grand
Gasket
Stove Pipe/Liner
Page 23