Table of Contents
Advertisement
Voyageur Grand
E. Glass Cleaning
•
Frequency: As desired
•
By: Homeowner
•
Clean glass with a non-abrasive glass cleaner. Abrasive
cleaners may scratch and cause glass to crack.
•
If the deposits on the glass are not very heavy, normal
glass cleaners work well. Heavier deposits may be
removed by using a damp cloth dipped in wood ashes or
by using a commercially available oven cleaner.
•
After using an oven cleaner, it is advisable to remove any
residue with a glass cleaner or soap and water. Oven
cleaner left on during the next fi ring can permanently stain
the glass and damage the fi nish on plated metal surfaces.
• A portion of the combustion air entering the fi rebox is de-
fl ected down over the inside of the door glass.
• This air fl ow "washes" the glass, helping to keep smoke
from adhering to its surface.
• When operated at a low burn rate, less air will be fl owing
over the glass and the smoky, relatively cool condition of
a low fi re will cause the glass to become coated.
•
Operating the appliance with the Burn Rate Air Control
and Start-Up Air Control all the way open for 15-20 min-
utes should remove the built up coating.
CAUTION! Handle glass assembly with care. Glass is
.
breakable
•
Avoid striking, scratching or slamming glass
•
Avoid abrasive cleaners
•
Do not clean glass while it is hot
Page 8
F. Inspect Firebrick & Replacement
Instructions
•
Frequency: After each ash removal
•
By: Homeowner
Replace the fi rebrick if they become crumbly and/or if
there is a 1/4 inch (6.35mm) gap between the bricks.
The fi rebox is lined with fi rebrick, which has exceptional
insulating properties. Do not use a grate; simply build
a fi re on the fi rebox fl oor. Do not operate appliance
without fi rebrick.
1. After the coals have completely cooled, remove all
old brick and ash from unit and vacuum fi rebox.
2. Remove new brick set from box and lay out to the
diagram shown in the instructions that come with
the replacement brick set.
3. Lay bottom bricks in unit.
4. Install rear bricks on the top of the bottom bricks.
5. Install side bricks. Slide top of brick under clips
on side of fi rebox and push the bottom of the brick
until it is fl ush with the side of the unit.
Use Part 832-0550 when ordering individual brick. Provide
brick dimension or copy the page in the service parts list, mark
the desired brick and take it to your authorized dealer.
7075-205B
October 12, 2015
Advertisement
Table of Contents
