Securing Stove Pipe/Liner To Flue Collar; Leveling Legs; Optional Elbow Flue Adapter Installation - Quadra-Fire VOYAGEUR-MBK Installation Manual

VOYAGEUR
B. Securing Stove Pipe/Liner to Flue Collar
1. There are 4 pre-drilled holes in the fl ue collar 90 degrees
apart. Attach the fl ue collar to the stove pipe/liner. If the
seal is questionable use high temperature sealant such
as stove mastic Figure 20.1.
2. Attach gasket to bottom side of fl ue collar with a thin coat
of silicone.
Flue Collar
Figure 20.1
C. Leveling Legs
1. Remove the 2 screws already installed on each leg.
2. Move legs to the desired height.
3. Re-install the screws to secure in place.
Remove 2 screws from both sides.
Adjust the legs up or down to level
appliance.
20
Gasket
Stove Pipe/Liner
D. Optional Elbow Flue Adapter Installation
Optional use of a Simpson Duravent 15° Universal Elbow
Part Number 4615 may be purchased directly through your
local Simpson Durvent Pipe Distributor or from your local
Quadra-Fire dealer, Part Number DV-6DLR-E15ADSS.
Figure 20.2 shows a vertical installation and also how to
create an optional 30° elbow installation.
The 15° elbow may be secured directly to the fl ue collar.
Follow the pipe manufacturer's instructions for using screws
or rivets for attachment. Most pipe manufacturer's 6 inch
(152mm) diameter fl ue liners may be attached directly to the
top of the 15° elbow.
A
30 degree
Figure 20.2
Flue
Adapter
Vertical 13-9/16 in. (344mm)
30 Degree 14-5/8 in. (371mm)
7063-513E
o
30
B
A
Vertical
A B
20-15/16 in. (532mm)
20-11/16 in. (525mm)
August 3, 2015
B