Yamaha RX-A730 Owner's Manual page 36

The following screen appears onthe TV.
• If any error message (such as E-l) or warning message (such as W-l)
appears, see "Error messages" (p.38) or "Warning messages" (p.39).
• To cancel the operation, disconnect the YPAO microphone before starting
the measurement.
• To configure the power amplifier assignment setting, press RETURN and
select "Manual Setup" (p.85).
6
• To check the measurement results, select "Result". For details, see
"Checking the measurement results" (p.37).
Use the cursor keys to select "Save/Cancer' and
press ENTER.
'_; To save the measurement results, use the cursor
keys (<_/_>) to select "SAVE" and press ENTER.
ENTER
RETURN
• Do not stand between the speakers and the YPAO microphone during the
measurement process (about 3 minutes).
• Move to the corner of the room or leave the room.
To start the measurement, use the cursor keys to
select "Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancelthe measurement t emporarily,pressRETURN.
The following screen appears on the TV when the
measurement finishes.
The adjusted speaker settings are applied.
• To finish the measurement without saving the result, select "CANCEL".
8 Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
• The YPAO microphone is sensitive to heat, so should not be placed anywhere
where it could be exposed to direct sunlight or high temperatures (such as on
top of AV equipment).
PREPARATIONS • Optimizing the speaker settings automatically (YPAO) I En 36