Notes On Remote Controls And Batteries - Yamaha RX-A730 Owner's Manual

Av
Hide thumbs Also See for RX-A730:
Table of Contents

Advertisement

1
To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.
2
Install this sound system in a well ventilated,
cool, dry, clean place - away from direct sunlight, heat
sources, vibration, dust, moisture,
and!or cold. For proper ventilation,
allow the following
minimum
clearances.
Top: 30 cm_ Rear: 20 cm, Sides: 20 cm
3
Locate this unit away from other electrical appliances, motors, or transformers
to avoid humming sounds.
4
Do not expose this unit to sudden temperature
changes
from cold to hot, and do not locate this unit in
an environment
with high humidity
(i.e. a room with a humidifier)
to prevent condensation
inside this
unit, which may cause an electrical shock, fire, damage to this unit, and/or personal injury.
5
Avoid installing this unit where foreign object may fall onto this unit and/or this unit may be exposed
to liquid dripping or splashing.
On the top of this unit, do not place:
-
Other components,
as they may cause damage and/or discoloration
on the surface of this unit.
-
Burning objects (i.e. candles),
as they may cause fire, damage to this unit, and/or personal injury.
-
Containers
with liquid in them, as they may fall and liquid may cause electrical
shock to the user
and/or damage to this unit.
6
Do not cover this unit with a newspaper,
tablecloth,
curtain, etc. in order not to obstruct heat radiation.
If the temperature
inside this unit rises, it may cause fire, damage to this unit, and/or personal injury.
7
Do not plug in this unit to a wall outlet until all connections
are complete.
8
Do not operate this unit upside-down.
It may overheat, possibly causing damage.
9
Do not use force on switches, knobs and/or cords.
10
When disconnecting
the power cable from the wall outlet, grasp the plug; do not pull the cable.
11
Do not clean this unit with chemical
solvents; this might damage the finish. Use a clean, dry cloth.
12
Only voltage specified on this unit must be used. Using this unit with a higher voltage than specified is
dangerous and may cause fire, damage to this unit, and/or personal injury. Yamaha
will not be held
responsible
for any damage resulting
from use of this unit with a voltage other than specified.
13
To prevent damage by lightning, keep the power cable and outdoor antennas disconnected
from a wall
outlet or this unit during a lightning
storm.
14
Do not attempt to modify or fix this unit. Contact qualified Yamaha service personnel
when any
service is needed. The cabinet should never be opened for any reasons.
15 When not planning to use this unit for long periods of time (i.e. vacation),
disconnect
the AC power
plug from the wall outlet.
16 Be sure to refer to the "Troubleshooting"
section of the Owner's
Manual on the CD-ROM
for
common
operating errors before concluding
that this unit is faulty.
17 Before moving this unit, press _ to set it to standby mode and disconnect the AC power plug from the wall outlet.
18 VOLTAGE
SELECTOR
(General model)
The VOLTAGE
SELECTOR
on the rear panel of this unit must be set for your local main voltage
BEFORE plugging into the AC wall outlet. Voltages are:
...........................................................................................................
AC 110-120/220-240V,
50/60Flz
19
Condensation
will form when the surrounding
temperature
changes
suddenly. Disconnect
the power
cable from the outlet, then leave this unit alone.
20
When using this unit for a long time, this unit may become warm. Turn the power off, then leave this
unit alone for cooling.
21
Install this unit near the AC outlet and where the AC power plug can be reached easily.
22
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. When you
dispose of batteries,
follow your regional regulations.
23
Excessive
sound pressure from earphones
and headphones
can cause heating
loss.
24
When replacing
the batteries,
be sure to use batteries of the same type. Danger of explosion
may
happen if batteries are incorrectly
replaced.
This unit is not disconnected from the AC power source as long as it is connected to the wall
outlet, even if this unit itself is turned off by C_.This state is called the standby mode. In this
state, this unit is designed to consume a very small quantity of power.
WARNING
TO REDUCE THE RISK OF RRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT
TO RAIN OR MOISTURE,
m Notes on remote controls and batteries
* Do not spill water or other liquids on the remote control.
* Do not drop the remote control.
, Do not leave or store the remote control in the following
conditions:
-
places of high humidity,
such as near a bath
-
places of high temperatures,
such as near a heater or stove
-
places of extremely
low temperatures
-
dusty places
. Insert the battery according
to the polarity markings (+ and -).
, Change all batteries if you notice the following
conditions:
-
the operation range of the remote contro! narrows
-
the transmit indicator does not flash or is dim
* If the batteries run out, immediately
remove them from the remote control to prevent an explosion
or
acid leak.
o If you find leaking batteries,
discard the batteries immediately,
taking care not to touch the leaked
material. If the leaked material comes into contact with your skin or gets into your eyes or mouth, rinse
it away immediately
and consult a doctor. Clean the battery compartment
thoroughly before installing
new batteries.
* Do not use old batteries together with new ones. This may shorten the life of the new batteries or cause
old batteries to leak.
,
Do not use different types of batteries (such as alkaline and manganese
batteries) together. Specification
of batteries may be different even though they look the same.
° Before inserting
new batteries,
wipe the compartment
clean.
* If the remote control is without batteries for more than 2 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be cleared. In such a case, install new batteries and set
the remote contro! code.
= Dispose of batteries according
to your regional regulations.
,
Keep batteries away from children. If a battery is accidentally
swallowed,
contact your doctor
immediately.
° When not planning to use the remote control for long periods of time, remove the batteries from the
remote control.
° Do not charge or disassemble
the supplied batteries.
is
This label is required to be attached to a product of which the temperature
of the top cover may hot during
operation.
3 En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents