Philco PEI 902 User Manual page 9

• Do not attach this range hood to a wall or cabinet furniture by tiling, plastering and do not glue it on using
silicone glue. The appliance is designed to only be installed on a wall / ceiling.
• We recommend that always two people perform the installation of the appliance.
If your range hood is designed to be mounted to the ceiling, adhere to the following instructions.
1) The range hood must only be suspended on ceiling beams or on load bearing ceiling beam connections.
2) Do not suspend the range hood on false ceilings.
3) The ceiling must have a load bearing capacity of at least 40 kg.
4) The ceiling thickness must be at least 30 mm.
IMPORTANT:
THE RANGE HOOD MAY ONLY BE CONNECTED TO THE ELECTRICAL GRID AFTER THE ENTIRE INSTALLATION
IS COMPLETE.
1) Installation of the hanging plate
Place the hanging plate on the ceiling and mark the points for drilling holes for the screws. Check that the
front part of the hanging plate (labelled "FRONT") is facing in the same direction as the control panel.
a) Into the designated locations A, B, C, D drill 10mm holes for screws. Depending on the surface of the
ceiling use an appropriate drill bit size.
b) Insert dowels into the drilled holes A, B, C, D. Check that the dowels are properly inserted.
c) Use screws (5.5 x 45) to attach the hanging plate to the ceiling. Check that the hanging plate if fi rmly and
properly attached.
2) Installation of the angle sections
The front angle sections must be installed in the left-right direction and the rear angle sections the other
way round.
Attach the angle section to the motor base according to the illustration. You can then set the height of
the range hood by setting various positions of the angle sections relative to the motor unit. Check that
all angle sections are installed at the same height and that the front part of the motor unit is facing in the
same direction as the front part of the hanging plate and control panel.
Copyright © 2015, Fast ČR, a. s.
F R O N
T
B
D
A
C
Hanging hole
Hanging plate
EN - 7
02/2015