Philco PEI 902 User Manual page 10

Connection of the front
angle sections – left to right
direction
3) Installing the chimney to the motor unit
Insert the inner chimney into the outer chimney. To temporarily join the chimney use the screws from the
motor unit. The chimney will then not fall during the installation to the hanging plate. The screw holes of
the inner chimney should fi t with the motor unit.
4) Attaching the motor unit to the hanging plate
Lift the motor unit and align the free ends of the angle sections with the corners on the hanging plate (see
illustration below). Ensure that the front part of the hanging plate is facing the same direction as the front
part of the motor unit and also as the control panel.
EN - 8
Copyright © 2015, Fast ČR, a. s.
Place for
connecting
F R O N
the angle
sections
Connection of the rear angle
sections – right to left direction
Front part of
T
the motor unit
02/2015