Stihl HLA 65 Instruction Manual page 9

Before Starting Work
WARNING
Always check your power tool for proper
condition and operation before starting,
particularly the trigger switch, trigger
switch lockout, switch lever and
retaining latch. The trigger switch,
trigger switch lockout and switch lever
must move freely and always spring
back to the idle position (retaining latch
on ‚). Never attempt to modify the
controls or safety devices.
WARNING
Your power tool is equipped with a
system designed to quickly stop the
cutting blades – they come to an
immediate standstill as soon as you
release the trigger switch and/or the
switch lever on the loop handle.
Check this function at regular short
intervals. To reduce the risk of injury, do
not operate your power tool if the cutting
blades continue to run. Contact your
servicing dealer.
WARNING
Never use a power tool that is damaged
or not properly maintained.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, grease
or resin in order for you to maintain a firm
grip and properly control your power
tool.
HLA 65, HLA 85
WARNING
The cutting blades must be properly
tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.) and for cracked, bent,
warped or damaged blades. Regularly
check the condition and tightness of the
cutting blades – with the motor stopped,
retaining latch on ƒ and battery
removed! Replace damaged cutting
blades before using the power tool.
Always keep blades sharp.
STIHL recommends that you always
spray the cutting blades with STIHL
resin solvent before starting work – with
the motor stopped, retaining latch on ƒ
and battery removed! You can obtain
this protective spray from your dealer.
Apply generously.
Check contacts in battery compartment
for foreign matter. Keep clean.
Fit the battery correctly – it must engage
audibly.
For specific starting instructions, see the
appropriate section of your instruction
manual.
WARNING
To reduce the risk of injury from blade
contact, be absolutely sure that the
cutting blades are clear of you and all
other obstructions and objects, including
the ground.
WARNING
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
During Operation
Holding and Controlling the Power Tool
(Version without Telescoping Shaft)
Always hold the unit firmly with both
hands on the handles while you are
working. Wrap your fingers and thumbs
around the handles.
Right-Handers
Right hand on the control handle and left
hand on the loop handle or handle hose
on the drive tube.
Left-Handers
Left hand on the control handle and right
hand on the loop handle or handle hose
on the drive tube.
Make sure you have firm and secure
footing and hold the unit so that the
cutting blades are always away from
your body.
English
7