Stihl HLA 65 Instruction Manual page 11

WARNING
Never attempt to operate
your power tool with one
hand. Loss of control of
the power tool resulting in
serious or fatal injury may
result. To reduce the risk
of cut injuries, keep hands and feet away
from the cutting blades. Never touch
moving cutting blades with your hand or
any other part of your body. Do not touch
the cutting blades while the motor is
running. If the cutting blades become
jammed by thick branches or other
obstructions, switch off the motor
immediately, move retaining latch to ƒ
and remove the battery before
attempting to free the blades.
WARNING
Do not overreach. Keep proper footing
and balance at all times. Special care
must be taken in slippery conditions (wet
ground, snow) and in difficult, overgrown
terrain. Watch for hidden obstacles such
as tree stumps, roots and ditches to
avoid stumbling. For better footing, clear
away fallen branches, scrub and
cuttings. Be extremely cautious when
working on slopes or uneven ground.
Working Conditions
Operate your power tool only under
good visibility and daylight conditions
only. Work carefully.
Do not cut any material other than
hedges or similar soft vegetation. Do not
cut stems greater than 17 mm
(11/16 inch) thick.
HLA 65, HLA 85
WARNING
If the vegetation being cut or the
surrounding ground is coated with a
chemical substance (such as an active
pesticide or herbicide), read and follow
the instructions and warnings that
accompanied the substance at issue.
WARNING
Inhalation of certain dusts, especially
organic dusts such as mold or pollen,
can cause susceptible persons to have
an allergic or asthmatic reaction.
Substantial or repeated inhalation of
dust and other airborne contaminants, in
particular those with a smaller particle
size, may cause respiratory or other
illnesses. Control dust at the source
where possible. Use good work
practices, such as operating the unit so
that the wind or operating process
directs any dust raised by the power tool
away from the operator. Follow the
recommendations of EPA/OSHA
/NIOSH and occupational and trade
associations with respect to dust
("particulate matter"). When the
inhalation of dust cannot be
substantially controlled, i.e., kept at or
near the ambient (background) level, the
operator and any bystanders should
wear a respirator approved by
NIOSH/MSHA for the type of dust
encountered.
If the hedge is very dusty or dirty, spray
the blades with STIHL resin solvent from
time to time during cutting. This helps
reduce blade friction as well as the
aggressive effects of sap and the build-
up of dirt particles.
Operating Instructions
WARNING
In the event of an emergency, switch off
the motor immediately, move retaining
latch to ƒ and remove the battery.
The power tool
has a large range.
In order to reduce
15m (50ft)
the risk of personal
or even fatal injury
to bystanders from
falling objects or inadvertent contact with
the moving cutter blades of your power
tool always keep bystanders at least
50 feet (15 m) away when the power tool
is running.
WARNING
Before you start work, examine the
hedge area for stones, fence wire, metal
or other solid objects which could
damage the cutting blades.
Take particular care when cutting
hedges next to or against wire fences.
Do not touch the wire with the cutting
blades. When working close to the
ground, make sure that no sand, grit or
stones get between the cutting blades.
Striking solid foreign objects such as
stones, fence wire or metal could
damage the cutting attachment and may
cause blades to crack, chip or break.
STIHL does not recommend the use of
your power tool when cutting in areas
where the blades could contact such
objects.
English
9