Honeywell MX7 Tecton User Manual page 244

Profile Parameters
Parameter Default
Edit Profile Default
SSID Blank
Client Name Blank
Power Save Fast
Tx Power Maximum
Bit Rate Auto
Auth Type Open
EAP Type None
Encryption None
Radio Mode BGA Rates Full Specify 802.11a, 802.11b and/or 802.11g rates when communicating with the AP. The
11 - 10
Explanation
A string of 1 to 32 alphanumeric characters, establishes the name of the Profile.
Options are Default or ThirdPartyConfig.
A string of up to 32 alphanumeric characters. Establishes the Service Set Identifier
(SSID) of the WLAN to which the client connects.
A string of up to 16 characters. The client name is assigned to the network card and
the device using the network card. The client name may be passed to networking wire-
less devices, e.g., Access Points.
Power save mode is On.
Options are: Constantly Awake Mode (CAM) power save off, Maximum (power saving
mode) and Fast (power saving mode). When using power management, use FAST for
best throughput results.
Maximum setting regulates Tx power to the Max power setting for the current regula-
tory domain.
Options are: Maximum, 50mW, 30mW, 20mW, 10mW, 5mW, or 1mW.
Setting the rate to Auto will allow the Access Point to automatically negotiate the bit
rate with the client device.
This parameter cannot be changed.
802.11 authentication type used when associating with the Access Point.
Options are: Open, LEAP, or Shared key.
Extensible Authentication Protocol (EAP) type used for 802.1x authentication to the
Access Point.
Options are: None, LEAP, EAP-FAST, PEAP-MSCHAP, PEAP-GTC, PEAP-TLS,
EAP-TTLS, or EAP-TLS.
Note: EAP Type chosen determines whether the Credentials button is active and also
determines the available entries in the Credentials pop-up window.
Type of encryption to be used to protect transmitted data. Available options may vary
by SCU version.
Options are: None, WEP (or Manual WEP), WEP EAP (or Auto WEP), WPA PSK,
WPA TKIP, WPA CCKM, WPA2 PSK, WPA2 AES, or WPA2 CCKM.
CKIP is not supported in the MX7 Tecton.
Note: The Encryption type chosen determines if the WEP Keys / PSK Keys button is
active and also determines the available entries in the WEP or PSK pop-up
window.
options displayed for this parameter depend on the type of radio installed in the MX7
Tecton.
Options:
• B rates only (1, 2, 5.5 and 11 Mbps)
• BG Rates Full (All B and G rates
• G rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps
• A rates only (6, 9, 12, 18, 24, 36, 48 and 54 Mbps
• ABG Rates Full (All A rates and all B and G rates with A rates preferred
• BGA Rates Full (All B and G rates and all A rates with B and G rates preferred
• Ad Hoc (when connecting to another client device instead of an AP)
Default:
BGA Rates Full (for 802.11a/b/g radio)
Note: It is important the Radio Mode parameter correspond to the AP to which the
device is to connect. For example, if this parameter is set to G rates only, the
MX7 Tecton may only connect to APs set for G rates and not those set for B
and G rates.