Precautions - Panasonic UB-5335 Operating Instructions Manual

Precautions

■ Installation
• Do not install the unit where it may be exposed to direct sunlight, near heating equipment, or near air-
conditioning vents as this may cause stretching and/or discoloration of the screen.
• Do not install the unit in strong sunlight or strong lighting. Proper copying may become impossible.
• Do not install the unit in locations where the temperature may drop below 10 °C (50 °F) or may change
suddenly as this may disable the unit's ability to make copies.
■ Screen Film
• Make thick and dark lines inside the copying area. Note that
any writing inside the shaded area (on right) cannot be copied.
• Do not allow writing to remain on the screen for an extended
period of time as it will become harder to erase.
• Do not erase with an overly dirty eraser.
• Do not touch the screen, write with markers, or erase while the
screen is moving as this may result in damage to the unit.
• Do not attach chart paper to the screen film for copying as this
may result in damage to the unit.
■ Markers and Erasers
• To maintain erasing quality, use only the included or designated markers and erasers (☞ page 37).
Use of accessories other than those included or designated (such as commercially available oil-
based markers) may damage the screen film or result in hard-to-erase markings.
• Be sure to replace the cap on markers after use, and store horizontally.
• Overshaking or dropping the marker may cause the ink to overflow.
• Do not use the markers for purposes other than writing or drawing. There is a possibility of damage.
• Do not leave the markers in locations subject to high temperatures. The ink may leak.
■ Thermal Transfer Film
• Do not store the thermal transfer film in a location subject to extreme changes in temperature (such as near
air conditioning or heating equipment) as this may cause condensation on the thermal transfer film and
result in poor print quality and/or paper jams.
• The length of one roll of designated thermal transfer film (Replacement film: UG-6001) is approximately
50 meters (164 ft.). One roll of thermal transfer film can make approximately 150 sheets of copies.
Note that the total number of copies may differ depending on the operating conditions.
The supplied thermal transfer film roll is short, and the number of possible copies will differ from
that of replacement film rolls. We suggest that you stock replacement film rolls.
25 mm (1 in.)
0 mm Copying area
(0 in.)
25 mm (1 in.)
1
12 mm
( 1 / in.)
2
9