Table of Contents
Advertisement
Precautions for use
This product is a 12G-SDI signal compatible Function Board equipped with
two ports that can install the SFP (Small Form-Factor Pluggable)/SFP+
module (referred to as "SFP module" hereinafter). By installing this product
to the projector manufactured by Panasonic Connect Co., Ltd., long-distance
transmission of the SDI signal via optical fiber cable will be possible without
a separate converter to convert from optical signal to electric signal.
Supported projector
This product can be used with following projectors. However, this product
cannot be used if the firmware version of the projector is earlier than the
following compatible firmware version. Use the product after updating the
projector to the latest firmware.
Supported projector
PT‑RQ25K, PT‑RQ18K
PT‑RZ24K, PT‑RZ17K
PT‑REQ12, PT‑REQ10, PT‑REQ80
PT‑REZ12, PT‑REZ10, PT‑REZ80
Note
f This manual omits the alphabets at the end of projector model numbers.
f This product may support the projectors that are not described in the table. Confirm
the "Operating Instructions" of the projector. The "Operating Instructions" can be
found on the following URL.
https://panasonic.net/cns/projector/
f The firmware version can be confirmed in the on-screen menu of the
[PROJECTOR SETUP] menu → [STATUS].
f For the update procedure of the firmware, access the latest information regarding
the firmware in the PASS website (https://panasonic.net/cns/projector/pass/). It is
necessary to register and login to PASS
*1 PASS: Panasonic Professional Display and Projector Technical Support Website
4 - ENGLISH
Precautions for use
Compatible firmware version
2.00 or later
2.00 or later
2.00 or later
1.00 or later
to access the PASS website.
*1
(As of June 2023)
Advertisement
Table of Contents
