Table of Contents
Advertisement
General Information
1
External Ethernet interface (through the LCP2 adapter) (MVME712B)
Built-in modem (refer to Appendix A) with front panel Telco modular jack
(MVME712-13 and MVME712AM)
Electrostatic Discharge (ESD) protection on front panel
Radio Frequency Interference (RFI) protection on front panel
Features of the LCP2 Adapter Board
The features of the LCP2 Adapter Board include:
A 50-pin connector permits SCSI cable connection to other SCSI devices
and/or to the MVME712B through a flat ribbon cable
SCSI terminating resistors mounted in sockets for end of cable or middle of
cable configuration
Terminator power is developed on the LCP2 adapter from the +5 Vdc on
connector P2 and is fused (1 amp) on the LCP2 adapter
A 64-pin connector interfaces the EIA-232D ports and printer port signals
to the MVME712x
Specifications
The MVME712 family module specifications are given in Table 1-1.
Power requirements
I/O ports
Operating temperature
Storage temperature
Relative humidity
Physical characteristics
(excluding front panel
and MVME712B)
1-2
MVME712-12/-13/A/AM/B Transition Modules and LCP2 Adapter Board UserÕs Manual
Table 1-1. MVME712 Family Specifications
Characteristics
Serial
Parallel
Height
Depth
Thickness
SpeciÞcations
+ 5 Vdc, 281 mA maximum (255 mA typical)
+12 Vdc
- 12 Vdc
Four multiprotocol (connected through the
LCP2 adapter)
Parallel printer port (connected through the
LCP2 adapter)
0 degrees to 55 degrees C at point of entry of
forced air (approximately 5 CFM)
- 40 degrees to 85 degrees C
5% to 90% (non-condensing)
9.187 inches (233.35 mm)
3.200 inches (80.00 mm)
0.063 inches (1.60 mm)
Advertisement
Table of Contents
