Windshield Wipers - Mahindra 2014 Scorpio S6 Owner's Manual

FEATURES AND CONTROL

8.28 Windshield Wipers

8.28.1 Wiper Control Stalk
The wipe/wash function can be activated only when the ignition is in "IGN" position.
Flick Wipe (MIST)
A
B Off
Intermittent (INT)
C
Low Speed (LO)
D
High Speed (HI)
E
8.28.2 Wiper Off
The wipe function is OFF when the wipe control stalk is in neutral position (B).
8.28.3 Flick-Wipe (Mist)
Push the wipe control stalk to position A for a flick-wipe, hold to operate the wipe
continuously (simultaneously lift the wiper stalk towards the steering wheel to
operate the wash). The stalk automatically comes back to position B when released.
8-16
8.28.4 Intermittent (INT) Mode
Intermittent (INT) wiping is selected when the wipe control stalk is pushed down to
position C. In the INT mode, the wiper operates on preset intervals of 4 sec.
The delay between each wipe can be programmed from 1 to 60 sec according to
the rain by the user.
Programming of the INT delay time is as follows;
• Turn the wiper stalk to position C, wiper will start wiping
• Turn the wiper stalk to OFF position, before wiper starts second wipe
• Turn the wiper stalk to position C again after the required delay and the same
• On keeping wiper ON position C, the wiper will wipe again with the programmed
W12H29
8.28.5 Low Speed Wiping
Push the wipe control stalk up to the position D to operate the wiper at a fixed low
speed.
8.28.6 High Speed Wiping
Push the wiper control stalk up to position E to operate the wiper at a fixed high
speed.
delay will be programmed
delay
© Copyright Mahindra & Mahindra Ltd. 082014