Table of Contents
Advertisement
Debugger General Information
Execute User Program
EXEC [ADDR]
The EXEC command is used to initiate target code execution. The specified
3
address ("ADDR") is placed in the target Program Counter (PC). Execution
will start at the target PC address.
Setup System Parameters
SETUP
Setup allows configuring certain parameters that are necessary for some I/O
operations (SCSI, VME, and Ethernet). When you execute this command, the
default value is displayed, if any is available, and then you are prompted for
input.
The SETUP command VME parameters do not stay through a reset. These
parameters are not saved to NVRAM. The remaining parameters (MPU Clock
Speed, Ethernet Address, Local SCSI Identifier) are saved to NVRAM, but are
not checksummed.
166-Bug>setup
MPU Clock Speed = "3300"?
Ethernet Address = 000000000000?
Local SCSI Identifier = "07"?
VME Slave Enable [Y/N]
VME Slave Starting Address
VME Slave Ending Address
VME Slave Address Translation Address
VME Slave Address Translation Select
VME Slave Control
VME Master Enable [Y/N]
VME Master Starting Address
VME Master Ending Address
VME Master Address Translation Address = 00000000?
VME Master Address Translation Select
VME Master Control
3-8
= N?
= 00000000?
= 00000000?
= 00000000?
= 00000000?
= 0000?
= Y?
= 40000000?
= 4FFFFFFF?
= 00000000?
= 0D?
MVME166 Single Board Computer Installation Guide
Advertisement
Table of Contents
