Cleaning Bare Floors; Using The Tools - Hoover SteamVac Owner's Manual

Cleaning bare floors

How to attach bare floor attachment
(available at additional cost)
Disconnect carpet cleaner from electrical
outlet.
To prevent possible leaking, remove clean
solution tank and recovery tank before posi-
tioning bare attachment.
Refer to Fig. 2.4 to remove clean solution
tank. Set tank aside (do not set tank on
furniture).
Refer to Fig. 2.8 to remove recovery tank.
With handle in upright position, tilt cleaner
back so that handle rests on the floor.
With foam strip (A) (located under the net-
ting) in position as shown, place attachment
on front of nozzle (B).
Make sure arrow on end of attachment
points in the direction as shown.
To clean floor
Read Before you begin cleaning. Do not use
the SteamVac™ carpet cleaner on hardwood
floors.
Fill clean solution tank with HOOVER Hard
Floor Cleaning Solution (available at addi-
tional cost if not included with your model)
according to instructions on pages 10 and 11.
Do not use any type of wax with your
SteamVac™ carpet cleaner.
Dry hands and plug carpet cleaner into a
properly grounded outlet.

Using the tools

3.5
A
C
www.hoover.com
(sold seperatly)
B
3.3
A
B
Push attachment against nozzle while rotat-
ing attachment downward until both ends
snap into place.
(Note: Some force may be required to rotate
and snap attachment into place.) Return car-
pet cleaner to upright position. Lower handle
and replace recovery tank.
Raise handle to upright position and reposi-
tion clean solution tank.
Step on handle release pedal and lower
handle to operating position; turn carpet
cleaner ON.
To release solution, press trigger. Slowly
move carpet cleaner forward and backward
over area to be cleaned.
To pick up dirty solution, release trigger and
slowly move carpet cleaner over area where
solution has just been dispersed. Use both
forward and reverse strokes.
Remove attachment from nozzle and rinse
in clean water. Do not remove plastic screen
or foam from attachment.
A. Powered Hand Tool has rotating brushes
for extra scrubbing action on small carpet
areas, carpeted stairs and upholstery.
B. Stair/Upholstery Nozzle has a built-in
brush to help provide the scrubbing action
some spots may need for removal.
C. Nozzle Cleaning Tool for removing lint
and/or debris from nozzle before storage
14
3.4