Mitsubishi Electric AE-200A Installation Manual page 9

Notes on the SD card installed on the AE-200/AE-50
● The SD card installed on the AE-200/AE-50 has been set up at the factory. Do not use other SD cards as proper functioning
cannot be guaranteed.
● The SD card installed on the AE-200/AE-50 differs from the ones sold on the market.
● The AE-200/AE-50 will not start up if the SD card does not function properly or is not installed.
● Only the SD card that has been formatted on AE-200/AE-50 can be used.
● Do not use the SD card installed on the AE-200/AE-50 for any other equipment.
Precautions for the replacement of the SD card
● Because of the characteristics of the SD card, read/write performance may degrade over time. It is recommended to replace
the SD card with our SD card (available as service parts) every 10 years, even if it is not damaged.
● If the SD card becomes damaged, the AE-200/AE-50 energy management data will be lost.
The AE-200/AE-50 settings data can be backed up from the AE-200/AE-50's LCD or the Web browser to an external
memory, and these data can be restored to the AE-200/AE-50. (Refer to the chapter [Maintenance] in the AE-200/AE-50
Instruction Book and the chapter [Utility] in the Instruction Book (Web Browser for Initial Settings) for details.) The energy
management data can only be output in a CSV file, and these data cannot be restored to the AE-200/AE-50. (Refer to
the chapter [Maintenance] in the Instruction Book (Web Browser for System Maintenance Engineer) for details.) It is
recommended to back up these data periodically.
● Only a qualified technician should insert or remove the SD card.
● Before inserting or removing the SD card, turn off the power to the AE-200/AE-50.
● If the SD card becomes damaged, consult your dealer for a replacement.
WT07137X01
9