Step 2 - Opening The Housing; Step 3 - Install Camera In Housing - Ikelite 6843.72 Instruction Manual

Step 2 - Opening the Housing

Lid Snaps have a Lid Snap Lock.
1. Push Lid Snap Locks forward and lift as shown. Open opposing Lid Snaps
simultaneously. Keep pressure on the Lid Snaps so they do not fly open
quickly. Some Lid Snaps have a lot of spring tension once they go over
center, so keep a firm grip on each Lid Snap. Lid Snaps may also be
opened one at a time.
2. Remove the Housing Back.

Step 3 - Install Camera in Housing

1. Make sure the camera battery is fully charged and a SD card is inserted into
the camera.
2. Pull top housing control knobs up for more clearance.
3. The Mounting Plate is secured to the inside bottom of the housing. The
camera Mounting Tray slides into the Mounting Plate. Use your index
finger and thumb to pull the Mounting Tray away from the Mounting Plate,
Diagram A, page 12. Use your other thumb to apply opposite pressure
against the bottom of the housing to assist in removal of the Tray if
necessary.
Push Forward
Lift
Lid
Snap
Lock
11