Attaching A Sync Cord To The Housing; Turn Camera On - Ikelite 6146.15 Instruction Manual

Attaching a Sync Cord to the Housing

The Housing Bulkhead is designed to accept only an Ikelite 5-pin TTL
Sync Cord.
1. Lightly lubricate the Sync Cord O-ring. Use ONLY Ikelite lubricant
(supplied with housing).
2. Remove Bulkhead Cap from Housing Bulkhead.
3. Line up the Sync Cord Pins with the corresponding Bulkhead
receptacles. Gently insert Sync Cord into Bulkhead. DO NOT force this
installation. If the Sync Cord does not seat properly inside the Bulkhead,
then the pins and receptacles are improperly aligned (repeat Step 3).
4. Tighten the Knurled Nut snugly using your Index finer and thumb. DO
NOT use pliers or other tools to tighten the Knurled Nut.
- Always remove the
Sync Cord from your
Housing when not in
use and replace the
Bulkhead Cap.

Turn Camera On

Turn the camera on and operate each of the housing controls to get a
feel for using the camera in the housing. Take a few test shots on land.
You are now ready to shoot underwater photos and video!
Sync Cord O-ring
Sync Cord Pin
Ikelite TTL
Sync Cord
Knurled Nut
Housing
Bulkhead
Bulkhead Cap
15