Cleaning The Drain Pump Filter - Baumatic BWD1409W Instruction Manual

o At the end of the wash cycle, you should leave the porthole door
open for a short period of time.

Cleaning the drain pump filter

IMPORTANT: Switch off your washer dryer and disconnect the plug
from your mains supply.
You should clean out the filter approximately every ten washes.
If the drain pump filter is not cleaned regularly, then your
appliance may find it difficult to pump out water efficiently.
o You should regularly check to see if any deposits have formed,
or there are any foreign bodies in the drain pump filter.
o Locate the drain pump filter flap that is on the base of the
appliance in the front right hand corner.
o When water no longer runs out of the bail tube, you can turn the
drain pump filter cover anti-clockwise. This will allow you to
remove the drain pump filter from its housing.
o Remove any debris from the drain pump filter by running it
under a tap.
o After cleaning, reinsert the drain pump filter into its housing.
Tighten the drain pump filter by turning it clockwise, you should
keep tightening it until you cannot turn it any further.
o Use a coin to open the drain pump filter flap.
o Pull out the bail tube that is to the left of the
drain pump filter. Place the end of the tube into
an adequately sized bowl and then remove the
cap from the end of it.
o Reinsert the cap into the end of the bail hose,
making sure that it is securely in place. Slide the
bail hose back into its original position and then
close the drain pump filter flap.
27