Installation Of Logs, Lava Rock & Ember Material - Majestic 33BDVR Installation Instructions And Homeowner's Manual

BDVR Series Direct Vent Gas Fireplace
Installation of Logs, Lava Rock & Ember Material
Unpack the logs from packaging and remove each log
from its wrapping materials.
The logs are fragile and should be
handled with care. Keep the packaging
material out of the reach of children and
dispose of the material in a safe manner.
The individual logs can be easily identified by the
numbers cast on the underside of each log.
Log Identification Chart
Location 33BDVR 36BDVR
Front Left -- BB11
Front Right BA9 BB12
Rear -- BB13
Top Right --
Rear Left BA7
Rear Fr Rt BA8
Top Center --
33BDVR
Refer to Figure 38
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear front right log (BA8) onto the rear log
support. Ensure the rear right end of the log is
located against the bracket bending up on the right
side of the support.
4. Fit the rear left log (BA7) onto the rear support.
Ensure the rear right end of the log is located
against bracket bending up on the right side of the
support.
5. Place the right rear log (BA9) in position by resting
the hole under the center of this log located over the
knob on the branch of the rear front right log, and
the front end of this log will also set against the
back wall of the deflector.
6. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 38) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
7. Scatter the lava rock material around the firebox
base.
Do not place any of the lava rock material
on the burner housing.
22
39BDVR 43BDVR
BC11 BD12
-- BD14
-- BD11
-- BC12 --
-- BC10 --
-- BC13 --
-- -- BD13
BA7
33BDVR
LG268
Fig. 38 33BDVR log placement.
36BDVR
Refer to Figure 39
1. Remove the top louvre assembly.
2. Remove the window frame assembly.
3. Fit the rear log (BB13) onto the rear log support.
Ensure the log's bottom holes are located on the
two pins of the support.
4. Place the front left log (BB11) onto the left cut out of
the rear log while the front of this log will set against
the back wall of the front deflector.
5. Place the front right log (BB12) in position by resting
the hole under the center of this log located over the
knob on the center rear log, and the front end of this
log will also set against the back wall of the
deflector.
6. Scatter the ember material over the front area of the
burner housing assembly. (Fig. 39) Do not pack this
material tightly, separate it when unpacked and
keep it in a loose condition.
7. Scatter the lava rock material around the firebox base.
Do not place any of the lava rock
material on the burner housing
assembly.
36BDVR
LG267
BB11
Fig. 39 36BDVR log placement.
BA8
Embers
BA9
BB13
Embers
BB12
10003357