Channel Master DVR+ User Manual page 35

Manually Updating Your DVR+ Software
If your DVR+ isn't connected to the Internet, follow this procedure to update the software manually.
1 Download the software update file from the Channel Master website to an empty USB
flash/thumb drive formatted as FAT or FAT32.
2
With your DVR+ receiver powered on (and not in standby mode), insert the flash drive with the
software update into one of the USB ports on the rear panel of your DVR+.
3
Wait for your DVR+ to detect the updated software and display the version information. When
prompted by the pop-up message, select CONFIRM to begin installing the update. See page
37 for more information about messages you may see displayed.
4
Wait for your DVR+ receiver to restart automatically and begin updating software. Do not turn off
or remove power from the DVR+ receiver until the entire update process has completed.
5
This process may take as long as five minutes, after which the DVR+ receiver will restart with the
updated software. You can then operate your DVR+ normally.
:: Menus and Options
32