Channel Master CM-7000PAL Quick Start Manual

Digital Video Recorder (DVR) Functions
Get to recorded
programs
Skip back
10 seconds
Reverse at 4
different speeds
Stop playback
or recording
Record a program
Skip Back 10 Seconds
Reverse at 4 Di erent
Quick Ways to Set a DVR Timer
Speeds
Stop Playback or
Highlight a future program in the Guide,
Recording
press the SELECT
your recording options from the
on-screen menu or press the
RECORD button.
Program Guide
Press SEARCH
instructions to locate a program you want
to record, then choose your settings.
Note: The Channel Master CM-7000PAL DVR
still records your programs when the receiver is
Search Menu
tuned off.
Device Codes
TV: ____ ____ ____ ____ VCR/DVD: ____ ____ ____ ____
AUX: ____ ____ ____ ____
See the User Guide for a list of device codes.
Signal
Issues
Freeze/Pause
Skip forward
30 seconds
Fast forward
at 4 different
speeds
Missing
Starts
Channel
playback
Remote
Control
Issues
button, and choose
DVR
Issues
and follow the on-screen
www.channelmaster.com
Troubleshooting
Verify the coax cable to the over-the-air antenna IN port is hand-tight and
connected to your over-the-air antenna.
Verify your antenna has not been moved out of proper alignment. This can
cause signal loss on some or all channels.
Reset the receiver by first powering it off, then unplugging it from the outlet
for 15 seconds, and plugging it back in. Power the receiver back on.
Check the signal strength on your channels. Using the remote control, press
MENU, select Setup, System Setup, Channel Setup, then Add a New Channel.
Find the channel in question and verify that it has a strong signal. Channels
showing signal strength below 60 may experience signal loss.
The Channel Master CM-7000PAL DVR is only able to tune to digital channels
and therefore will not tune to a channel that is still broadcasting in analog.
Visit www.antennaweb.org to find out which channels in your area are
broadcasting in digital or analog.
To tune to an analog channel using your analog TV, press the ANALOG
PASS-THRU button on the remote control, then tune to the channel using
your TV's remote control.
Press the button; it should illuminate. For another device that isn't
responding, press that device's MODE button (for example, press TV
control a TV).
Replace batteries with four new alkaline AAA batteries. Be sure the batteries
are installed as indicated on the diagram inside the battery compartment.
To program your remote control for another device, refer to the User Guide.
Verify event timers are set as DVR timers, not as Auto-Tune timers.
If you run out of space on the DVR, unprotected events are erased, starting
with the oldest. Protect those you want to keep.
For Additional Information
1.877.746.7261 User Guide
CM.PUB.CM7000PALDVR.QSG.200912
CM-7000PAL DVR
digital Video recorder (dVr)
& HdtV Over-the-air receiver

quick start

guide
to
178232