Advertisement
48. Connect the room light harness 3-pin connector
and the i -VES harnesses terminal to the monitor
console 3-pin connector and monitor console
terminal.
i -VES HARNESS
MONITOR HARNESS
TERMINAL
3-PIN CONNECTOR
MONITOR
CONSOLE 3-PIN
MONITOR
CONNECTOR
CONSOLE
TERMINAL
MONITOR
CONSOLE
2326300T
49. With an assistant holding the monitor console,
thoroughly clean the area where the cushion
tapes will attach, and where the monitor console
terminal and the 3-pin connector will attach.
Secure the 3-pin connectors and terminals you
just connected to the underside of the vehicle
frame with the cushion tape as shown.
TERMINALS
VEHICLE
FRAME
3-PIN
CONNECTORS
CUSHION
TAPE
MONITOR
CONSOLE
CUSHION
TAPES
WIRE
WIRE
TIES
TIES
i -VES
HARNESS
VEHICLE HARNESS
2326311T
50. Secure the i -VES harness to the underside of the
vehicle frame with the two cushion tapes.
51. Secure the i -VES harness to the vehicle harness
with four wire ties in the areas shown.
52. Position the monitor console on the monitor
bracket and install the two 5 x 16 mm washer-
screws and the two 5 x 25 mm washer-screws.
Install the two screw caps, then reinstall the left
and right lenses. Do not pinch the i -VES harness
and monitor harness between the monitor console
and the monitor bracket.
MONITOR
MONITOR
CONSOLE
BRACKET
FRONT
5 x 25 mm
WASHER
RIGHT
SCREW
LENS
LEFT
SCREW
LENS
CAP
5 x 16 mm
WASHER
SCREW CAP
2326322T
SCREW
53. Along the front pillar, secure the i -VES harness to
the vehicle harness with the four wire ties.
i -VES
HARNESS
WIRE TIES (4)
VEHICLE
HARNESS
VEHICLE
CLIP
2306042M
Page 14
Advertisement
