Advertisement
58. Route the other end of the subharness behind
navigation unit or audio unit, and plug the
subharness 20-pin connector into the rear of the
navigation unit or the audio unit, then reinstall the
center panel. On navigation equipped vehicle,
place the subharness connector between the
vehicle bracket and air duct.
With Navigation System
CENTER PANEL
Without Navigation System
CENTER PANEL
16 of 20
NAVIGATION
UNIT
SUBHARNESS
20-PIN
CONNECTOR
2326361T
AUDIO UNIT
SUBHARNESS
20-PIN
CONNECTOR
2326371T
AII 24046 (0208)
59. Remove the vehicle harness clip, and pull it out
toward you.
PLAYER
BASE-
BRACKET
VEHICLE HARNESS CLIP
(Remove.)
60. Install the player base-bracket to the vehicle
frame, then install the two 6 mm flange nuts while
holding the bracket firmly against the vehicle
frame.
61. Position the FM modulator on the player base-
bracket and install the 5 x 8 mm washer-screw.
DIN HARNESS
90° DIN
HARNESS
TERMINAL
FM
MODULATOR
ANTENNA
LEAD
5 x 8 mm
WASHER-
SCREW
62. Plug the 90° DIN harness terminal into the FM
modulator (Not the i -VES harness).
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
VEHICLE
FRAME
VEHICLE
FRAME
6 mm
FLANGE
NUT
2530270T
FM
MODULATOR
PLAYER BASE-
BRACKET
2326382T
Advertisement
