Honda 08A23-2E1-010 Installation Instructions Manual page 13

42. Plug the room light harness 3-pin connectors in
between the rear interior light and vehicle 3-pin
connectors.
VEHICLE 3-PIN
CONNECTOR
ROOM LIGHT
HARNESS 3-PIN
CONNECTOR
CUSHION
TAPE
REAR
INTERIOR
LIGHT
43. Using isopropyl alcohol, thoroughly clean the area
where the two cushion tapes will attach. Secure
the room light harness to the headliner with the
two cushion tapes in the areas shown.
44. Reinstall the rear room light.
45. Slide the five square-neck bolts into the holes in
the vehicle frame from the top down, Use strips of
masking tape to hold the bolts in position. Do not
remove the clip.
SQUARE-NECK
BOLTS (5)
© 2002 American Honda Motor Co., Inc - All Rights Reserved.
ROOM LIGHT
HARNESS 3-PIN
CONNECTOR
MONITOR
HARNESS
2326260T
VEHICLE FRAME
CLIP
(Do not
remove
the
clip.)
FRONT
MASKING TAPE
SQUARE-
NECK BOLT
2326270T
46. Install one collar over each square-neck bolt (use
a small piece of masking tape to hold the collars),
and install the monitor bracket and the 4 mm
flange nuts.
MONITOR
BRACKET
47. Remove the left and the right lenses from the
monitor console, then install the monitor gasket
on the console.
RIGHT
LENS
AII 24046 (0208)
4 mm FLANGE NUTS (5)
LEFT LENS
MONITOR
CONSOLE
MONITOR
GASKET
SQUARE-
NECK
BOLTS (5)
2326282T
2326290T
13 of 20