Tone Calling (1750 Hz) - Yaesu FT-252 Operating Manual

If the repeaters in your country require a 1750-Hz burst tone for access (typically in
Europe), you can set the [ VOL/SQL ] key to serve as a "Tone Call" switch instead. To
change the configuration of this switch, we again use the Set Mode to help us.
1. Press the [ SET/ATS ] key to enter the Set mode.
2. Rotate the DIAL knob or press the [ p ] / [ q ] key to select
Set Mode Item 23:
3. Press the [ SET/ATS ] key momentarily to enable adjust-
ment of this Item.
4. Rotate the DIAL knob or press the [ p ] / [ q ] key to select "
5. Press the PTT switch to save the new setting and exit to normal operation.
To access a repeater, press and hold in the [ VOL/SQL ] key for the amount of time speci-
fied by the repeater owner/operator. The transmitter will automatically be activated, and
a 1750-Hz audio tone will be superimposed on the carrier. Once access to the repeater
has been gained, you may release the [ VOL/SQL ] key for activating the transmitter
thereafter.
FT-252 O
peraTing
CTCSS/DCS Operation
Tone Calling ( 1750 Hz )
/ .
M T-CAL
M
anual
" on the display.
T-CALL
21