Changing The Tx Deviation Level - Yaesu FT-252 Operating Manual

Table of Contents

Advertisement

standards take this into account), if you find that your receiver squelch does not open
when both you and the other station are using a common DCS code, you or the other
station (but not both) can try the following:
1. Press the [ SET/ATS ] key to enter the Set mode.
2. Rotate the DIAL knob or press the [ p ] / [ q ] key to select
Set Mode Item 14:
3. Press the [ SET/ATS ] key momentarily, then rotate the
DIAL knob or press the [ p ] / [ q ] key to select one of the
following modes:
: Encoder, Normal; Decoder, Normal
/
T
RX N
:
Encoder, Normal; Decoder, Reverse (Inverted)
RX R
:
Encoder, Reverse (Inverted); Decoder, Normal
TX R
: Encoder, Reverse (Inverted); Decoder, Reverse (Inverted)
/
T
RX R
4. When you have made your selection, press the PTT switch to save the new setting
and exit to normal operation.
5. Remember to restore the default setting to "
Normal) when done.

Changing the TX Deviation Level

In many areas of the world, channel congestion has required that operating channels be
closely spaced. In such operating environments, it often is required that operators use
reduced deviation levels, to reduce the potential for interference to users on adjacent
channels. The FT-252 includes a simple method of accomplishing this:
1. Press the [ SET/ATS ] key to enter the Set mode.
2. Rotate the DIAL knob or press the [ p ] / [ q ] key to select
Set Mode Item 45:
3. Press the [ SET/ATS ] key momentarily to enable adjust-
ment of this Set Mode Item.
4. Rotate the DIAL knob or press the [ p ] / [ q ] key to set this Set Mode Item to "
." In this configuration (HALF DEVIATION active), the transmitter's devia-
ROW
tion will be approximately ±2.5 kHz, and the received audio output level will be
increased, for easier listening on the narrow signal.
5. When you have made your selection, press the PTT switch to save the new setting
and exit to normal operation.
The "normal" setting for the deviation (when this Menu Item is set to WIDE) is ±5
kHz.
FT-252 O
peraTing
Miscellaneous Settings
.
/
DCS.N
R
.
WID.NAR
M
anual
" (Encoder; Normal, Decoder;
/
T
RX N
NAR-
51

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ft-257

Table of Contents