Burner Identification/Verification - Heat & Glo 6000CLX-IPI-T Owner's Manual

Note: The base refractory must be
removed to access screws.
BASE REFRACTORY
Figure 3.5 Base Refractory Removal
Figure 3.7 Burner Identification
Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. AN • 2/16
6000CLX
NOTCH LOCATION
BURNER BOTTOM
NG
6000C
6000CL
6000CLX
6000CBV
8000C
8000CL
8000CLX
8000CBV
Figure 3.6 Valve Assembly Removal
D. Burner Identification/Verification
The burner may be accessed for identification and veri-
fication purposes. This task should be performed by a
qualified service technician. The base refractory, valve
plate, refractory and grate do not need to be removed to
access the burner assembly. The logs and fiber burner
top need to be removed to access the burner. Disconnect
the pilot from the burner before removal. See Figure 3.7
for burner identification chart. Notch patterns are located
on bottom side of burner.
8000CLX
NOTCH LOCATION
LP
Note: Notch location may vary by model.
BURNER BOTTOM
17