Heat & Glo 6000CLX-IPI-T Owner's Manual page 64

2
HORIZONTAL GRATE BAR
Figure 7
Log #3 (2170-723): Mate the groove located on the bottom of Log #3 with the right log placement protrusion on top of Log #1.
After groove and protrusion have been fitted together, mate the groove located on the bottom of Log #3 with the horizontal
grate bar and far right grate tine. Log #3 will sit down on top of both the grate tine and the horizontal grate bar. See Figure 7.
Log #4 (2170-724): Place Log #4 in the left log indentation on the burner top. See Figure 2. Slide Log # 4 from right to left
under Log #2 to fit completely and securely into the indentation. See Figure 8. Nose of log #4 should be pulled to fit securely
against right hand side of log indentation.
FLAT AREA
2
4
Figure 9
Log #5 (2170-725): Place Log #5 in the right log indentation on the burner top. See Figure 2. Ensure the log fits completely
and securely in the recessed indentation. See Figure 9. Log #5 should be pulled to the left hand side of log indentation.
Log #6 (2170-726): Mate the groove located on the lower end of Log #6 with the fourth grate tine (from left to right) as shown
in Figure 10. Set the other end of Log #6 on the flat area located on top of Log #4. See Figure 9. Log #6 will also rest against
center grate tine. When properly installed, Log #6 will rest securely on all 3 contact points, not allowing movement or shifting.
2
4
LOG CONTACTS GRATE TINE
Figure 11
64 Heat & Glo • 6000CLX-IPI-S, 6000CLX-IPI-T, 8000CLX-S, 8000CLX-IPI-T • 2166-900 Rev. AN • 2/16
RIGHT GRATE TINE
1 3
1
3
5
1
3
7
5
6
2
4
Figure 8
LOG #6 CONTACTS TOP OF LOG #4
2
4
LOG CONTACTS GRATE TINES
Figure 10
Log #7 (2166-727): Place back (unnotched) end of Log
#7 on the flat area on the top of Log #5. Log #7 must be
pulled tight to the locating notch. Pivot the front (notched)
end of Log #7 to the right until the notch of Log #7 contacts
the grate tine located 4th from the left as shown in Figure 11.
NOSE
1 3
FLAT AREA
LOCATING
1
NOTCH
3
5
6
2170-945C