Vehicle Disassembly; Passenger Side Scuff Plate Removal; Passenger Side Front Trim Removal - Mazda 0000-8F-Z80 Installation Instructions Manual

6. VEHICLE DISASSEMBLY

Note
• Be careful not to damage or lose any parts removed from the vehicle since they will be reused.
Negative battery terminal
Front Scuff Plate
(4)
(3)
Clip B
Tab B
Hook B
Clip
Clip
Cap Nut
Cap Nut
Front Side Trim
Front Side Trim
Vehicle Front
Vehicle front
Tab A
Hook A
(1)
(2)
Pin A
Clip A
Pin B
Vehicle Front
Front Side Trim
Front Side Trim
(Backside)
(Backside)
Clip
Clip
Seaming Welt
Weather strip
1. Place the vehicle in park with the parking brake set.
2. Disconnect negative battery terminal and wrap tape
around it to insulate.
Warning
• When the negative battery cable is connected during
operation, it may cause electric shock or personal
injuries. Disconnect the negative battery cable before
removal / installation.
Bolt tightening torque: 4.0 - 6.0 N•m (2.9 - 4.4 ft•lbf)

Passenger side scuff plate removal

1. Use shaded area to pull (1) and lift (2) Passenger side
Front Scuff Plate to detach Tab A and Clip A.
2. Use shaded area to pull (3) and lift (4) Passenger side
Front Scuff Plate to detach Tab B and Clip B.

Passenger side front trim removal

1. Peel back the Seaming Welt.
2. Remove Cap Nut.
3. Remove Front Side trim.
6