Table of Contents
Advertisement
11. REINSTALLATION / INSPECTION
2 x Wire Ties (White)
MMS LED
Connector
Lower panel (Passenger's side)
Glove compartment
Standard value: 0.5-2.5mm
Standard value: 0.5-2.5mm
MMS harness
LED
RES Diagnostic
Connector
Vehicle Harness
1.
Disconnect the LED from the MMS Harness and discard
2.
Secure MMS harness LED connector to the vehicle
harness with 1 wire tie (white).
3.
Secure the RES Diagnostic connectors to the vehicle
harness with 1 wire tie (white).
4.
Reinstall parts in the reverse order of the installation
procedure [Section 6 Vehicle Disassembly].
5.
After installing the passenger's side lower panel and glove
compartment, measure the clearance, and verify that the
measurement value is within the specification shown in
the figure.
Caution
•
If the measurement value is not within the specification after
measuring the clearance between the passenger's side
lower panel and glove compartment, adjust the passenger's
side lower panel to the proper position.
6.
Refer to "Required servicing after disconnection/
connecting negative battery cable" in the vehicle workshop
manual or the owner's manual to restore the vehicle
functions.
7.
Attach key tag to Advanced Key.
23
Hide quick links:
Advertisement
Table of Contents
