Table of Contents
Advertisement
3. BEFORE INSTALLATION
REQUIRED TOOLS
• 10mm Socket Wrench
• Electrical Tape
• Panel Removal Tool
• Pliers
• Primer (3M Promoter-4298)
WARNING
When the negative battery cable
is connected during operation, it
may cause electric shock or other
personal injuries. Disconnect the
negative battery cable before
removal/installation.
CAUTION
Using improper tools may cause
damage and or broken parts.
Use the correct tool for the job.
WORKSHOP
MANUAL
• When the negative battery cable is removed, the clock, radio, trim meters and other memories will be
erased. Make sure to record the content of the memory.
• Refer to the Workshop Manual for removal and installation of vehicle parts. Not following the procedures for
removal/installation in the Workshop Manual could result in an accident or vehicle malfunction.
4. CONNECTION USING ELECTRO-TAP
1
Electro tap
2
Vehicle wiring harness
Harness
• Scissors
• Torque Wrench
• Soft clean cloth
• IPA (Isopropyl alcohol)
When connecting or disconnecting
connectors, grasp the connectors,
not the wires. Otherwise a short,
an accident from poor contact or
fire may occur.
Wrap protective tape around
screwdrivers and fastener
removal tools to prevent
scratching the vehicle.
Vehicle wiring harness
Vehicle wiring harness
5
Lock
4
Firmly press using pliers
3
Terminal
• Taped Flathead Screwdriver
• Squeegee
• Phillips Screwdriver
Do not pull the harness with
excessive force. Doing so can
cause a breakage or a short-
related accident, as well as an
electrical short or fire.
Put the removed parts and the
parts in the kit on the protective
sheet to prevent scratches.
Branch connection procedure using electro tap.
1.
Insert the vehicle wiring harness into the electro tap.
2.
Fold the electro tap as shown in the figure and lock it.
Caution
•
Firmly engage the lock part until a click sound is heard.
3.
Insert the harness to the end of the electro tap.
4.
Firmly press the electro tap terminal using pliers.
5.
Fold the electro tap in the direction of the arrow shown in
the figure and lock it.
4
• Mat
• Glass Cleaner • Nipper
Park the vehicle on a level ground.
Set the vehicle on park (P) and
apply the parking brake. Be sure to
turn the ignition switch off, otherwise
the vehicle can move, causing
personal injury or vehicle damage.
Excessive length of wire tie may
interfere with other parts and
cause damage. Cut unnecessary
part up to about 5 mm {0.19 in}
from the fixed point.
Hide quick links:
Advertisement
Table of Contents
