Cx-3; Mazda2 - Mazda 0000-8F-Z80 Installation Instructions Manual

CX-3

Vehicle wiring
Vehicle wiring
harness clip

Mazda2

Vehicle wiring harness
18 pin connector
[Vehicle wiring harness 18 pin connector]
(Connector viewed from wiring harness side)
F
Insert hood switch harness (White)
terminal to empty terminal.
Vehicle wiring harness
18 pin connector
[Vehicle wiring harness 18 pin connector]
(Connector viewed from wiring harness side)
Terminal:A (Black)
Hood switch harness (Black)
Hood switch harness
harness clip
3 x Wire Ties
(Black)
Vehicle Front
Shroud panel
Hood switch harness
Vehicle wiring
harness clip
3 x Wire Ties
(Black)
Vehicle Front
Shroud panel
Hood switch harness (White)
Insert Terminal
Vehicle front
Vehicle Front
Hood switch harness (Black)
Electro tap and
electrical vinyl tape
Vehicle front
Vehicle Front
CX-3
9. Route the hood switch harness along the vehicle wiring
harness and secure it with 3 wire ties (black).
Mazda2
9. Route the hood switch harness along the vehicle wiring
harness and secure it with 3 wire ties (black).
<Terminal insertion procedure>
<Terminal insertion procedure>
Terminal
Terminal
10. Insert the hood switch harness (white) terminal to the
empty terminal of the vehicle wiring harness 18 pin
connector (terminal F).
Caution
• When connecting a terminal to a connector, always refer
to the following, <Terminal insertion procedure>.
• Connect the harness terminal to the specified signal line
because a system or vehicle malfunction may occur if it
is connected incorrectly.
11. Branch connect the hood switch harness (Black) to the
vehicle wiring harness 18 pin connector (terminal A (Black))
using an electro tap, and wrap the electro tap using
electrical vinyl tape.
Caution
• Connect the electro tap to the specified signal line because
a system or vehicle malfunction may occur if it is connected
incorrectly.
• For branch connection procedure using electro tap, refer to
[4. CONNECTION USING ELECTRO TAP] on page 4.
11
(b) Insertion terminal
Terminal
Terminal
Retainer
Retainer
(a) Remove retainer
(c) Reinstall retainer