Omega Remote Notes - Travis Industries 21 TRV Installation Manual

5 0 Optional Equipment

Omega Remote Notes

If you are using the Omega remote option with the 21 TRV, follow the directions below for installing the
receiver and attaching the accent light leads (if applicable – see the following page).
Receiver Installation
Attach the two wires labeled "SOLENOID
OPTIONAL" to the modulating regulator
e
(orientation does not matter).
a
Disconnect the control cover and
pull it forward (leave the wires
attached). Remove and discard
the regulator knock-out (use tin
snips or wire cutters).
d
Replace the control cover.
b
Remove the jumper connector on
the wiring harness and place it near
the gas control valve (it is required if
you wish to remove the remote).
Attach the molex connector from the
receiver to the molex connector on
the appliance.
© Travis Industries
Make sure the power
is disconnected!
Control Cover
c
Place the receiver to the right of the gas control valve (it is a
very tight fit). Make sure the wires do not contact the
burner or any moving parts (use lock ties if necessary).
NOTE: When installing the receiver, make sure to place the
receiver with the "Learn" button in a forward position. Before
replacing the control cover, make sure to verify the remote
works correctly. Once the control cover is installed, the
"Learn" button can not be readily accessed.
4080207
(for qualified installers only)
IF USING AN ACCENT LIGHT
Follow the directions listed under
"Accent Light Receiver Connection".
IF NOT USING AN ACCENT LIGHT
Secure the two white wires, making
sure they do not contact the burner or
any moving parts.
100-01185_000