Travis Industries 21 TRV Installation Manual page 13

Converting the Fireplace to Rear Vent (continued)
Attach the cover plate to
the top of the fireplace.
NOTE: You will need to
tuck the front edge of the
cover plate under the upper
standoff.
© Travis Industries
Installation
Flatten the exhaust restrictor following
the steps shown below.
Bend the heat
shield as shown
to the right.
Remove the 4 screws on the angled
top of the fireplace and attach the heat
shield with these screws.
Attach the inner flue
assembly with four
screws (make sure
the gasket is in place
while attaching).
NOTE: Install the flue
assembly with the diffuser
to the bottom.
(for qualified installers only)
4080207
1 3
Attach the outer
flue assembly
with four screws
(make sure the
gasket is in place
while attaching).
100-01185_000