Table of Contents
Advertisement
1)
Enter the SIM 46-24 mode.
2)
Press [EXECUTE] key. (A4/11" x 8.5" or A3/11" x 17" paper is
automatically selected.)
The color patch image (adjustment pattern) is printed out.
3)
Set the color patch image (adjustment pattern) paper printed in
procedure 2) on the document table.
Place the printed color patch image (adjustment pattern) paper
on the document table so that the thin lines on the paper are
on the left side. Place 5 sheets of white paper on the printed
color patch image (adjustment pattern) paper.
4)
Select [FACTORY] target, and press [EXECUTE] key.
When the color balance is customized with the manual color
balance adjustment (SIM 46-21) according to the user's
request and the color balance is registered as the service tar-
get with SIM 63-7, if the color balance is adjusted to that color
balance, select the service target.
MX-3610N ADJUSTMENTS AND SETTINGS 4 – 43
The copy color balance adjustment is automatically executed
to print the color balance check patch image. Wait until the
operation panel shown in procedure 5) is displayed.
Low
density
A
B
C
D
E
F
G
5)
Press [OK] key on the operation panel.
According to data of this adjustment, the initial setting of the
halftone image correction is performed.
After pressing [OK] key, the initial setting of the halftone image
correction is started. During the operation, "NOW REGISTER-
ING THE NEW TARGET OF HALFTONE PROCON." is dis-
played. This operation takes several minutes.
After completion of the operation, "PLEASE QUIT THIS
MODE" is displayed.
Do not cancel the simulation until "PLEASE QUIT THIS
MODE" is displayed.
High
density
Y
M
C
Bk
H
I
J
K
L
M
N
O P
Q
Hide quick links:
Advertisement
Table of Contents
