Clearances To Combustibles; Hearth Extension/Floor Protection - Quadra-Fire TOPAZ-MBK-IPI Installation Manual

B. Clearances to Combustibles
When selecting a location for the appliance it is important to
consider the required clearances to walls (see Figure 3.2).
WARNING! Risk of Fire or Burns! Provide adequate
clearance around air openings and for service access. Due
to high temperatures, the appliance should be located out of
traffic and away from furniture and draperies.
NOTICE: Illustrations reflect typical installations and are FOR
DESIGN PURPOSES ONLY. Illustrations/diagrams are not
drawn to scale. Actual installation may vary due to individual
design preference.
NOTICE: Some carpet materials may be sensitive to radiant
heat from the appliance causing discoloration or odor.
F
B
or *B
A
"A" measurement is from
stove top, not side
Alcove Installation
Note: Dimensions are minimums as shown and may not be typical for all applications. An alcove installation is
shown above on left.
*Installation of optional blower does not effect minimum clearance dimensions, however, if frequent blower removal
service is desired, clearance to the wall should be increased to *B and *C Dimensions.
Model
TOPAZ-MBK-IPI
Inches
TOPAZD-PMH-IPI
TOPAZD-MBK-IPI
Millimeters
TOPAZD-CSB-IPI
Figure 3.2 Appliance Locations
8 Quadra-Fire • TOPAZ-MBK-IPI, TOPAZ-D-PMH-IPI, TOPAZ-D-MBK-IPI, TOPAZ-D-CSB-IPI Installation Manual • 2341-980_R10 • 11/15
G
E
A
(MAX.) D
A B *B
6-1/2 3
165 76 127
C. Hearth Extension/Floor Protection
CAUTION! Risk of Fire or Injury! Install appliance on
a stable, level, platform or floor strong enough to support
appliance without tipping.
A non-combustible hearth pad is not required. However,
the floor beneath the appliance must be stable, level, and
strong enough to support the appliance without a tipping
hazard. It is permissible to place the appliance on carpet.
NOTE: Flooring beneath appliance may reach 90
degrees plus room ambient temperature. Check with
flooring manufacturer for maximum temperature allowed
on flooring surfaces.
H
C
or *C
C *C D
5 1 2 66-1/4
25 51 1683
C
or *C
A
E
F G
(MAX.)
36 40 36-3/4
914 1016 933
G
A
H
Top of Side of
pipe pipe
3 1
76 25