Quadra-Fire TOPAZ-MBK-IPI Installation Manual page 33

5. Remove rear access plate and gasket by removing four
screws. Save the screws.
REAR PLATE
AND GASKET
Figure 6.5
6. Place rear access plate and gasket over top vent and
attach with the four screws removed in Figure 6.2.
Figure 6.6
7. Remove six screws under the rear access plate removed
in Figure 6.5. See Figure 6.7. Install inner pipe adapter
and new gasket (included with kit) using six screws. See
Figure 6.8.
Figure 6.7 Remove Screws Under Rear Access Plate
33 Quadra-Fire • TOPAZ-MBK-IPI, TOPAZ-D-PMH-IPI, TOPAZ-D-MBK-IPI, TOPAZ-D-CSB-IPI Installation Manual • 2341-980_R10 • 11/15
Figure 6.8 Attach inner collar adapter to rear flue vent.
Remove Screws
Figure 6.9
8. Install starting collar with gasket or high-temp sealant
9. Remove safety barrier and front casting, if not previously
10. Using a #2 Phillips screwdriver, remove the three screws
REMOVE
SCREWS (6)
11. Remove the logs and refractory.
12. The pilot needs to be lifted slightly to accommodate the
13. Using a 1/4 in. bit, remove the two burner mounting
to rear vent opening. Attach with screws removed in
Figure 6.5.
Place grille gently into the opening on top of appliance.
The grille does not have a hole and is included with the
kit.
removed, by grasping it at the top and lifting up. The top
casting may need to be lifted slightly to accommodate
removal of the front casting. See Figure 6.10.
on the front glass assembly and take the glass assembly
off the appliance. See Figure 6.11.
burner removal. Using 1/4 in. bit, remove the two screws
that attach the pilot to the burner. Remove the pilot shield
and lift the pilot slightly until it clears the pilot mounting
tabs. See Figure 6.12.
screws from each side of the burner. Remove the two
screws that hold the burner to the rear firebox wall. See
Figure 6.12. Remove burner from appliance.