Kemppi mastertig mls 2300 acdc Operation Instruction Manual page 19

SETuP-function
upslope current
dependency (*C)
Downslope current
dependency (*C)
TIg Antifreeze (*C)
mmA Antifreeze (*C)
vRd (*C)
2T downslope cut off
Tacking automatics
Limitation of rate of current
rise with high currents
mmA/TIg method selection
with remote control (C*)
SearchArc On/Off
Current freeze function
memory channel selection
with Up/Down buttons (C*)
Activation of the Plus/minus
buttons (C*)
Water cooler flow guard (C*) A17 on
Water cooler automatic
control (C*)
Water cooler temperature
guard (C*)
Automatic remote control
device recognition (C*)
Tail arc
© keMppi oy
*C = Common: applies to all memory
display channels
Factory setting with a grey background
A1 on the upslope time is determined by the current.
off the upslope time remains as set.
A2 on the downslope time is determined by the
current (the user may set the slope gradient).
off the downslope time remains as set.
A3
on tig antifreeze on.
off tig antifreeze off.
A4 on mma antifreeze on.
off mma antifreeze off.
A7 on vrd mode: idle voltage < 35 v
off normal idle voltage
A8 on in 2t mode, cut off the downslope with a quick
push of the start button.
off Quick push has no effect.
A9 on if welding has lasted less than 3 seconds, no
downslope when welding is stopped.
off tacking automatics off.
A10 on
if the current is over 100 a and upslope is 0.0
sec., there is a 0.2-second slope from half the
welding current.
off Current rises directly to maximum.
A12 on tig = the start of remote control scale.
mma = the end of the scale.
off remote control as a normal current regulator.
A13 on searcharc on.
off searcharc off.
A14 on during the downslope, the current can be
'frozen' at a certain level by pushing the start
button.
off freeze function off.
A15 on
the Plus/minus buttons on the remote control
can be used to select the memory channel.
off the buttons adjust the current.
A16 on the Plus/minus remote control is always active.
off the Plus/minus remote control is active only
when selected by pressing the remote button.
flow guard on.
off flow guard off.
A19 on automatic control on.
off Water cooler runs constantly.
A20 on Water cooler temperature guard selected.
off temperature guard off.
A21 on automatic recocnition on, control cannot be
selected if it is not connected.
off automatic recocnition on/off. Controller can be
selected even if it is not connected.
A22 on* tail arc on. * 4t log
off** tail arc off. ** minilog
Mastertig MLs™ 300 aDCD / 0743 – 1