Solenoid; Carriage Guide 2 Assy - Brother DX-2000 Service Manual

3.3

Solenoid

(1) Remove the solenoid spring.
(2) Unfasten the two screws.
(3) Remove the solenoid.
(4) Detach the retaining ring E3.
(5) Remove the switch arm and the solenoid link.
Note1 : Since the solenoid assy harness is connected to the conductor,
Note2 : Mount the solenoid without leaving the harness exposed
Solenoid link assy
Solenoid
3.4

Carriage Guide 2 Assy

(1) Unfasten the screw A and the screw B.
(2) Slide the carriage guide 2 assy slightly in the direction of the arrow, and
disengage the hooks.
(3) Remove the carriage guide 2 assy.
Note1 : When removing the carriage guide 2 assy, take care not to
handle it with care.
excessively.
Retaining ring E3
Switch arm
Figure 4.31
damage the solenoid assy harness.
Hook
Screw A
cup S M3 x 5)
Figure 4.32
IV-16
Inside frame unit
Solenoid spring
Screws, cup M3 x 5
Solenoid assy harness
Carriage guide 2 assy
(Taptite,
Washer
Screw B (Shoulder screw M3-4 x 4.4)
Hook
Solenoid assy harness