Duplex I/F Pcb - Brother DX-2000 Service Manual

(4) Pass the fulcrum shaft R through the outside frame unit, the fulcrum spring and
the inside frame unit.
(5) Using nippers, set the other end of the fulcrum spring (inside frame unit side) in
the inside frame unit.
Outside frame unit
Retaining ring E6
2.3

Duplex I/F PCB

(1) Disconnect the paper pressure motor harness, the cover sensor harness assy
and the cassette sensor assy from the Duplex I/F PCB assy.
(2) Unfasten the screw.
(3) Remove the Duplex I/F PCB from the outside frame L.
Outside frame L
Taptite, cup S M3 x 5
Retaining ring E4
Fulcrum spring
Fulcrum shaft R
Figure 4.19
Figure 4.20
IV-10
Inside frame unit
Bearing collar
Duplex I/F PCB
Cassette sensor assy
Cover sensor harness assy
Paper pressure motor harness