Selecting Track Plotting Interval - Furuno GP-150 Operator's Manual

2. TRACK
Are you sure to erase ?
ENT: Yes MENU: No
Figure 2-6 Prompt for erasure
of track
5) Press the NU/CU ENT key.
2.9 Selecting Track Plotting
Interval
The plotting interval determines both how the
track will be reconstructed on the display and
track storage time. A shorter interval provides
more accurate reconstruction of track line,
however total storage time is reduced. The
plotting interval can be selected by time or
distance. Plotting by distance offers the
advantage that the track is not stored when
the vessel is anchored.
Plotting interval by time
The setting range for plotting by time is 00 to
60 minutes.
1) Press the MENU ESC key.
2) Press 2 to display the TRACK/MARK
SETUP menu.
TRACK/MARK SETUP
Track Rec
Time
(01'00)
Mark Shape
Mark Line
Event Mark
: Select
ENT: Enter MENU: Escape
Figure 2-7 TRACK/MARK SETUP menu
2-4
3) Press
4) Press
5) Enter plotting interval in four digits. To
6) Press the NU/CU ENT key.
7) Press the MENU ESC key.
Plotting interval by distance
The setting range for plotting by distance is
0.00 to 99.99 nautical miles. To plot all track,
enter 00.00.
1) Press the MENU ESC key.
2) Press 2 to display the TRACK/MARK
3) Press
4) Press
5) Enter plotting interval. To enter 0.1
6) Press the NU/CU ENT key.
7) Press the MENU ESC key.
Dist
(00.50nm)
or to select Track Rec.
to select Time.
enter 30 seconds, for example, press 0,
0, 3, 0.
SETUP menu.
or to select Track Rec.
to select Distance.
nautical miles, for example, press 0, 0, 0,
1.