Deleting Route Waypoints; Replacing Route Waypoints - Furuno GP-150 Operator's Manual

2
Using previously registered waypoints
Enter waypoints in the order they will be
traversed not by waypoint number order.
) Press . The reverse video on the
waypoint on route planning screen
disappears.
) Press or to select waypoint
number.
) Press the NU/CU ENT key. Selected
waypoint number appears on the route
editing screen. The distance and
time to go indications to the first waypoint
entered are blank.
1 ) To enter other route waypoints repeat
steps and .
11) Press the MENU ESC key to finish.
Note: To return to the route editing screen
press .
4.5 Deleting Route
Waypoints
1) Press WPT RTE and 6 to display the
route list.
2) Press or to select route.
3) Press to display route editing screen.
4) Select the waypoint to delete.
5) Press the CLEAR key.
) Press the NU/CU ENT key.
) Repeat steps 4 through
deleting waypoints.
) Press the MENU ESC key. The route is
rearranged to reflect the change.
to continue
4. A
4.6 Replacing Route
Waypoints
1) Press PT RTE and 6 to display the
route list.
2) Press or to select route.
3) Press to display route editing screen.
4) n the route editing screen place the
cursor on waypoint number to replace.
5) Enter new waypoint number.
) Press the NU/CU ENT key. The message
shown in igure 4 1 appears.
This waypoint already exists
Are you sure to change ?
ENT: Yes MENU: No
Figure 4-16
hen the waypoint number entered at
Note:
step 5 is not registered the message
This waypoint not registered. Copy
original data to this o.
Press NU/CU ENT key to copy the
position data.
) Press the NU/CU ENT key.
) Press the MENU ESC key twice.
AT PLA
appears.
4-7